• English
  • Deutsch
  • Italiano
SANYO Component Europe GmbHSANYO Component Europe GmbH
ProductsSANYO

Pedal Juice

+++ New: Pedal Juice now available in Europe +++ Enjoy the freedom to play whenever and wherever you want to +++ New: Pedal Juice now available in Europe +++ New: Pedal Juice now available in Europe +++ Enjoy the freedom to play whenever and wherever you want to +++

 

 

 

Rechargeable 9V Power for Music Equipment

 

Pedal Juice is equipped with high-capacity lithium-ion batteries and provides stable, long-lasting 9V power for music effects devices. Power to the Pedal! 

 

Up to 50 Hours of Continuous, Quiet, Clean, Stable Power – from the First Note to the Last

Stage and studio recording musicians often need to replace the 9V batteries well before they have been exhausted, in order to prevent any disruption during a musical performance. This only results in users having to purchase, and then discard costly, single-use, alkaline batteries. Pedal Juice eliminates those pesky 9V battery replacements. The sound quality also deteriorates when the 9V battery voltage falls below the proper operating range of an effects box. Now, the Pedal Juice provides users with up to 50 hours of continuous, quiet, clean, stable power, even as the battery drains. It can be fully recharged in only 3.5 hours using the included AC adaptor. Getting power to effects pedals has never been easier.

 

Eliminates AC Ground Loops - So Your Tone Comes Through Loud and Clear
Many effects boxes, graphic equalizers, portable amps, and recorder products operate using a 9-volt DC power source. AC adapters and 9V dry-cell batteries are the typical sources used to power these types of devices. AC power can present problems when used to operate musical electronic products. Musicians must set up their gear near to AC electrical outlets. AC power may inadvertently add electrical noise interference (i.e., AC ground loops, spurious noise, hum, etc.) into the desired signal path. With a 500mA load, a typical AC adapter introduces much more ripple noise into the signal path as compared to the clean power produced by Pedal Juice.

 

 

 

   Pedal Juice                        Typical AC adapter used

                                        for powering musical equipment 

 

For the great number of musicians who have experienced noise and hiss when using AC adapters, Pedal Juice provides welcome relief by providing continuous, quiet, clean, stable 9V power.

 

 

Two 9V DC outputs - Power Multiple Devices; Pedals, Multi-Effect Units, and Portable Recorders
The Pedal Juice is equipped with a high-capacity rechargeable lithium-ion battery, providing a stable and long-lasting 9V power source for analog and digital effects units and other electronic music gear. The unit provides two separate 9VDC outputs on the back and includes two single device connection cables and one reverse polarity adapter for easy connectivity.

 

Rechargeable Many Times – Save Money and the Environment
Compared to conventional 9V batteries which lose voltage quickly and must be discarded, Pedal Juice maintains its power level over long periods of time and can be recharged hundreds of times. Pedal Juice is built to withstand the most demanding power applications for stage and studio performances. It can power a 10mA effects pedal for up to 50 hours, or a 100mA pedal board for up to 27 hours. With a 500mA current draw (more typical in large multi-effects applications, or in powering synthesizers and multi-track recorders), Pedal Juice can provide steady 9V DC power for about four hours compared to a 9V battery which will operate for about 30 minutes time.

  

 

Devices Usage Times

Analog effects unit (Distortion / Overdrive, etc.: Current used about 10 mA)

Approx. 50 hours

Digital effects unit (Digital Delay / Digital Reverb, etc.: Current used about 50 mA)

Approx. 27 hours

Digital multi effects unit, mini amp, or graphic equalizer (Current used about 100 mA)

Approx. 17 hours

Multitrack recorder or synthesizer (Current used about 300 mA)

Approx. 7 hours

Electronic drums or percussion (Current used about 1,000 mA)

Approx. 2 hours

Three effects units (Overdrive + Chorus + Digital Delay: Current used about 80 mA)

Approx. 20 hours

  

Powering Various Effects Pedal Configurations

Pedal Juice represents a milestone for guitar players by providing SANYO’s Lithium-Ion battery power for effects pedals. The following example shows a number of possible effects pedal configurations. Of course, there are virtually hundreds of possible configurations which are based on each musician’s personal preference and taste. Each effects pedal in the chain operates at 9VDC power and consumes some amount of current as measured in milliamps (mA). The following examples provide estimated usage times for various effects pedal configurations.

 

  

Powering Other Types of Devices
Pedal Juice isn’t just for guitarists. It can also be used to power a wide range of 9V DC musical instruments, multi-effects units, portable amplified speakers and other electronics devices. It provides convenient, portable power that can be reused time and time again, anywhere you need it. The following examples provide estimated usage times for these types of applications.

 

  

Power Status LED Indicator 
A three-stage power indicator makes it easy to see the remaining battery power level. The LED light changes color in three stages from green (over 60% power remaining), to orange (30% to 60% remaining), to red (less than 30%). This enables musicians to see the battery level, at a glance, during their performances.

 

 

 

Convenient One-Button ON/OFF Power Switch for

All Effects
Pedal Juice includes an ON/OFF power switch which allows the user to easily to turn the power of all connected music effects devices ON or OFF with the press of a single button. This is very convenient since many effects devices do not include their own ON/OFF switch and must be manually unplugged from AC power.

Water and Shock Resistant - JIS IPX3 Compliant Water Resistant Enclosure
The portable, rugged, and road-worthy design of the SANYO Pedal Juice will meet the challenge of the most demanding band and touring environments. In short, it is built to withstand the abuse typical of a gigging musician’s equipment. It is housed in a standard, effects pedal-sized enclosure for easy integration into standard pedal boards. Pedal Juice has achieved a JIS IPX3 water resistant compliance level rating. IPX3 is a Japanese testing standard for water resistance which states that no damage will occur when water is sprayed at a vertical angle of up to 60 degrees from both sides. The durability of Pedal Juice will ease the mind of the working musician who performs in nightclubs and outdoor settings.

 

Power to the Pedal!

 

 

Click here to watch the Pedal Juice promotion movie.