Chargers

The microprocessor controlled quick-charger MQR06 is perfectly made for the demanding user. The plug is molded to the case for direct use into an A/C wall socket. If you take off the European plug, you will be able to use the US-plug, which is placed behind it. A very special feature is the individual charging, whereas each single cell gets charged on it´s own. The charging progress gets checked and ended for each single cell via Peak-Cut-Control. On top you have the possibility to choose between 3 charging tempos. 1-4 eneloops at normal speed need to get charged 220 minutes. Only 2 eneloops just need to get charged half of the time- 110 minutes. If you only want to charge one single eneloop, you can even do this with triple speed in only 75 minutes.

The MDR02 is designed to be used during travel, when small size and a wide A/C-voltage range are important. Line voltages from 100V to 240V can be used to recharge your eneloop. To save on weight and size it´s capability is limited to two batteries only, however as time is often short while travelling the speed of charging has been increased. Two batteries can be charged in less than four hours. The charger comes with a detachable A/C-power cable with either a Euro-plug or UK-plug. The MDR02 can charge either one or two batteries of size AA or AAA at once. 

Last but not least is the MDU01, a charger with a USB-connector to be used with your PC or laptop. This is an elegant alternative to the MDR02 for people travelling with their Laptop. It´s even smaller and lighter and no worries about the line-plug and line voltage any more. The MDU01 can charge either one or two batteries of size AA or AAA at once.